Alloy Density Calculator Goes Live

Folks,

Over the past few years I have been surprised at the interest in the Excel based alloy density calculator that I developed. Thanks for your interest!

In light of this interest, team Indium suggested that it be made available on the web for all to use. Find it here.

I have written some other software that I will be discussing in future posts. One even perfroms the calculations to time balance the component placement machines on a line. Another matches the solder paste spec to the reflow profile. Stay tuned.

Cheers,

Dr. Ron

Share your thoughts by COMMENTING. Or, email the blogger at rlasky@indium.com.

Posted by Dr. Ron Lasky on August 8th, 2008 at 7:41 PM

Comments (add your comment)

There are no comments on this entry yet.

Comment on this entry

↑ top of page

← Back to Blog Home Page

Email Dr. Lasky

rlasky@indium.com

Recent Entries

This weblog is licensed under a Creative Commons License:

Subscribe (entries)

Subscribe (comments)

The opinions expressed here are the personal opinions of Dr. Ronald C. Lasky. Content published here is not read or approved by the Indium Corporation and does not necessarily represent the views and opinions of the company. In addition, they are not guaranteed to be correct, complete, or up-to-date. By using this blog site you understand that any information or advice is of a general nature and may not apply to your specific situation. It is the reader’s responsibility to confirm and verify all information prior to implementing any endeavors based on the information. This blog/website should not be used as a substitute for competent personal advice from a trusted professional.